Press the Power button to turn the equipment back on. I have the remote control codes arranged alphabetically. Click to see the manufacturers list of codes. If the device responds, you have successfully programmed your Philips universal remote. Turn all of your devices off, and then manually turn on the device you want to program. Release the Setup button 4. For a list of codes visit the Related Link.
Follow the instruction and it will work. Check out the or look up a that can do it all. All mode buttons flash twice if you correctly enter this number. Sick of having multiple remote controls on your coffee table and not finding one when needed. Take the you-Verse remote control, then do the following:.
You will find my diary, rants, thoughts, personal experiences and general information. After choosing this option, select the device you wish to program, and then follow the instructions. Code from Step 1 for the desired. When device is supported, all functions are supported. If none of these methods work for you, then you may have an off market or older device.
When the code works, press the Mute button on the Philips universal remote and the code will be stored. If support is not accomplished, there is no way to find out if it should be supported until you find that the remote works for you. If the code that you tried didn't work, try another code and follow the same steps. One of these should work. That the blogger makes no warranty, express or implied, nor assumes any legal liability or responsibility for the accuracy, correctness, completeness or use of any information, products, services, or related graphics that are available on or through this web site nor represents that its use would not infringe on privately owned rights; 2. Each page on this web site must be read in conjunction with this disclaimer and any other disclaimer that forms part of it. The Mode button is one of multiple buttons at the top of the remote.
Simply click the Set Up Another Device button at the end of the instructions. To implement it, simply follow these instructions:. Press the Power button to turn the equipment back on. You can pick buttons based on your preference, instead of someone else's. Since you want the att button to be active to change channels this may be a good choice.
So I have included basic troubleshooting steps that may help readers especially Uverse and Time Warner users. The technician was supposed to set everything up for you, but sometimes things happen. Release the Setup button 4. Least expensive is a model 200 refurb at newegg. But there is no business driver to spend money to assure full support of all functions on all possible devices. Turn all of your devices off, and then manually turn on the device you want to program.
This article has also been viewed 280,830 times. The U-verse remote is effective for some subset of basic control functions on the most popular equipment, The Harmony provides full control of complex setups across a broader range of equipment. The red indicator blinks once, then stays on. All of the U-verse remotes are supposed to be able to control any U-verse box. To program- Enter an arbitrary code that may be difficult or impossible to determine or step through every possible entry using the search method. Did a post have a solution that worked for you? This writeup shows that, even though the basic descriptions sound the same, there are functional advantages to the Harmony.
You only have 10 seconds to begin programming or the remote will reset itself. For you to program the remote control, you need to hold the mode key tv, dvd, aux and the enter button. The inclusion of any links does not necessarily imply a recommendation or endorse the views expressed within them. Leonides asked this question 9 months ago. This article has also been viewed 280,830 times. To determine which model you have, look on the back of the remote for the model number before you begin. Select the manufacturer, and then select the type of device, and follow the on-screen instructions.